Fourth try on a print. Tried to add some adhesive to the bed to get it to stick better. Watched the first two layers and went to bed. Woke up to a printer on strike.
Fourth try on a print. Tried to add some adhesive to the bed to get it to stick better. Watched the first two layers and went to bed. Woke up to a printer on strike.
I had this happen. Pop the whole hotend in the oven on the warm/hold setting for a bit and it should come off fairly easily.
Careful not to break the heating assembly thermostat wires. They’re super delicate, and I managed to break them when removing a blob from my mini a while back.