• ayyy@sh.itjust.works
    link
    fedilink
    arrow-up
    1
    ·
    2 months ago

    How did you integrate this into your door reliably without interfering with the regular lock mechanism?

    • pearsaltchocolatebar
      link
      fedilink
      arrow-up
      2
      ·
      2 months ago

      You could position the sensor/switch on one of the cardinal directions so it wouldn’t be in the way of the mechanism.

        • pearsaltchocolatebar
          link
          fedilink
          arrow-up
          1
          ·
          2 months ago

          I haven’t actually done this, I was just brainstorming. It shouldn’t be too hard of a project, though. The easiest would just be an esp32 chip, limit switch, and small battery and power circuit.

          You position the switch were the deadbolt latch hits it in the open or closed position (I’d do open personally). Using esphome with homeassistant would make programming it a breeze.

          You’d need to figure out a housing, which is why I wish there was an off the shelf product. I might design one eventually, but it shouldn’t be a huge lift for anyone who is familiar with 3d modeling.