It’s cheaper to manufacture one device for the whole world. Moreover, states like California are probably going to also force manufacturers to use USB C. And more than 1 in 10 Americans lives in CA.
While it might be cheaper, it’s rarely possible. Different countries have different frequencies and other stuff, so you still need to make different SKUs for different markets.
That used to be the case, but most phones now use radios that can support necessary frequencies and protocols globally. It’s also helped that the network side has also been more standardized compared to the 3g days.
Even in the US, only some high end phones support mmWave. It’s never required for service as the few areas covered by mmWave also have low or mid band 5g coverage too.
True. It basically means the connector component will be universal. Which will lower the manufacturing cost of it.
That said, it also means that the 1st party and third party peripheral market will be universal. It would be a nightmare if companies like Anker and Belkin had to make two of every damn peripheral.
It’s cheaper to manufacture one device for the whole world. Moreover, states like California are probably going to also force manufacturers to use USB C. And more than 1 in 10 Americans lives in CA.
While it might be cheaper, it’s rarely possible. Different countries have different frequencies and other stuff, so you still need to make different SKUs for different markets.
That used to be the case, but most phones now use radios that can support necessary frequencies and protocols globally. It’s also helped that the network side has also been more standardized compared to the 3g days.
5G in Europe and in the US is completely different still.
As far as I can tell it’s just the C band frequency range, and radios supporting either generally support both.
Many manufacturers released their phones without mmWave antennas outside of the US. Like iPhone 13 or Pixel 6.
Even in the US, only some high end phones support mmWave. It’s never required for service as the few areas covered by mmWave also have low or mid band 5g coverage too.
That’s not what this thread is about.
True. It basically means the connector component will be universal. Which will lower the manufacturing cost of it.
That said, it also means that the 1st party and third party peripheral market will be universal. It would be a nightmare if companies like Anker and Belkin had to make two of every damn peripheral.