Wouldn’t advise turning off ipv6. We are probably getting near the point where some public services will disable or offer v4 as only best effort, and when this happens, your connectivity will be broken for certain things if you disable v6. Heck, it’s to the point now where all my home hosted services are v6 only.
The better solution is to just get a VPN that supports ipv6 like airvpn or mullvad. I think pia disables ipv6 while the tunnel is up, which is better than disabling ipv6 altogether.
To validate the tunnel is working properly you can use something like this.
There is also a Torrent Address detection section, that when you activate it, will provide a magnet link that will show your ip to ensure that it is tunneled properly.
Many ISPs are no longer handing out even 1 public ipv4 address per account, and instead opting for CGnat which further breaks and stratifies the internet.
Tmobile for example is 464xlat which is even worse than cgnat since it requires tampering with dns responses.
Given the situation many ISP are in, most serious companies offering services on the internet have supported ipv6 for a long time now in order to offer the most competitive service possible. And with cloudflare now serving up a large amount of traffic, a lot of all traffic is v6.
My ISP routinely has problems on IPv4. Even while it’s fully operational with very low ping, IPv4 performance is poor compared to IPv6. Add in NAT, port forwarding and all the mess IPv4 brings into the picture I can’t believe people are still advocating for disabling IPv6.
Don’t be so quick to paint everyone with the same brush. I have had my Ccna since 2003, he.net ipv6 sage since like 2009, netadmin for literally millions of nodes. Architect for even more.
And I still disable ipv6 on most machines for personal use.
I actually had to disable ipv6 just because Halo Infinite wouldn’t load the UI. A couple websites were unreachable with it on too. Seems like it will still be awhile.
It probably isn’t which one that’s the problem, it’s more likely your setup.
If you can, try disabling IPv6 entirely, turn it off in your operating system and your router. I’d bet you’re leaking past the VPN that way.
Wouldn’t advise turning off ipv6. We are probably getting near the point where some public services will disable or offer v4 as only best effort, and when this happens, your connectivity will be broken for certain things if you disable v6. Heck, it’s to the point now where all my home hosted services are v6 only.
The better solution is to just get a VPN that supports ipv6 like airvpn or mullvad. I think pia disables ipv6 while the tunnel is up, which is better than disabling ipv6 altogether.
To validate the tunnel is working properly you can use something like this.
https://ipleak.net/
There is also a Torrent Address detection section, that when you activate it, will provide a magnet link that will show your ip to ensure that it is tunneled properly.
Dude, it’ll be a longer time than this guy is going to be on his ISP before he’ll need to worry about ipv6.
OP - feel free to disable it, IMO.
Seriously; they’ve been talking about v6 for like 3 decades now. I’ll believe it when I see it.
Many ISPs are no longer handing out even 1 public ipv4 address per account, and instead opting for CGnat which further breaks and stratifies the internet.
Tmobile for example is 464xlat which is even worse than cgnat since it requires tampering with dns responses.
Given the situation many ISP are in, most serious companies offering services on the internet have supported ipv6 for a long time now in order to offer the most competitive service possible. And with cloudflare now serving up a large amount of traffic, a lot of all traffic is v6.
Believe it or not, but IPv6 is here and gaining ground.
Most ISPs already use it, what are you on about
My ISP routinely has problems on IPv4. Even while it’s fully operational with very low ping, IPv4 performance is poor compared to IPv6. Add in NAT, port forwarding and all the mess IPv4 brings into the picture I can’t believe people are still advocating for disabling IPv6.
Yeah, people who think this just don’t know what the hell they are talking about
Don’t be so quick to paint everyone with the same brush. I have had my Ccna since 2003, he.net ipv6 sage since like 2009, netadmin for literally millions of nodes. Architect for even more.
And I still disable ipv6 on most machines for personal use.
Have you ever tried NATing v6 on a router from 2019? good fucking luck
As long as your ISP is handing out a block of IPs, you don’t need NAT for v6.
I’m talking about NATing your v4 app over v6.
Why would I want to support IPv4 in 2023? Lol
Mullvad doesn’t allow portforwarding anymore iirc
I actually had to disable ipv6 just because Halo Infinite wouldn’t load the UI. A couple websites were unreachable with it on too. Seems like it will still be awhile.
WireGuard is increasingly popular as far as I can tell. And if I understand correctly, designed more for IPv6.
I just noticed I have ipv6 disabled in Mullvad. It has caused me no issues. Should I enable it?
If you want to, then sure. For torrenting, it’s not necessary, but may be helpful. I do occasionally see ipv6 peers.