If only there was some way I could have known to try this sooner! /s

Story: I wanted to try printing with petg, since I’ve read how much easier it is. But with a new roll I just had a really hard time. Lots of stringing, poor adhesion, and it just seemed like no amount of my usual fiddling would really make it better.

Somewhere I read that even new filament can benefit from drying, because maybe it wasn’t stored in the best way, or maybe it’s older than you think. I also read about putting the roll on the print bed, heating it up and covering it for a long time, since I don’t have a filament dryer. I did that for about half a day, and then sealed the roll in a ziptop bag with a silica packet because I needed a break from it. A week later and, it seems much better!?

Either the drying, the break, or something else seems to have helped a lot! Happy printing everyone.

  • zipsglacier@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    0
    ·
    1 year ago

    oh, I’ve actually been thinking that people in really dry climates must have a great time; I guess the dry air alone isn’t enough though!

    • bigredgiraffe@lemmy.world
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Okay glad it wasn’t just me then haha. I think it was Zach from VoidStar that mentioned he lived in Denver area in one of his videos and I was like “wait a second, he has a whole dry room…” and gave it a whirl and the results spoke for themselves.