So I was thinking of adding USBC PD to my ender 3v2 for a off grid setup. Is it possible or have I gone mad with USBC? I know it’s possible with my old monoprice select mini because of its low power requirements.

  • LastYearsPumpkin@feddit.ch
    link
    fedilink
    English
    arrow-up
    2
    ·
    11 months ago

    You could theoretically split some of that power from multiple sources though. Run one USB-C line to power the hot end, one to run the bed, and one for the electronics and motors.

    Would get pretty complicated pretty quick, but it might work with a LOT of effort.

    • empireOfLove@lemmy.one
      link
      fedilink
      English
      arrow-up
      1
      ·
      11 months ago

      That would be difficult because you would need to somehow separate the power control MOSFET’s from the driver boards so that the controller can still feed them a PWM signal for temp control, but the power would be provided from a separate dedicated usbPD driver board for each set of MOSFETs. At that point it’s really not worth the effort.

      • evidences@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        11 months ago

        Could you not just do something similar to what printers with mains heated beds do and run the bed/hotend heater to a relay and different power bank?

        • empireOfLove@lemmy.one
          link
          fedilink
          English
          arrow-up
          1
          ·
          11 months ago

          Sure, but on these fully DC printers all the power control hardware is integrated into the main board and supplied from a single main power rail. You’d have to basically build a separate power control board with that would allow you to isolate those MOSFET’s on their own power rail and then jump the PWM control signal over to it from the main board. Decent amount of electronics knowledge and skill required to pull that off.

          • evidences@lemmy.world
            link
            fedilink
            English
            arrow-up
            1
            ·
            11 months ago

            Yeah but why would you need to do that? You’re isolating the second power source behind a relay and switching it using the normal controller.