I’ve finally been connected to a fiber connection 2,5/1Gbps! 🥳 Now I want to share my connection with my neighbor and so I’ve installed 3 PCIx dual 1GB nic (I’m out of PCIe slots 🤷‍♂️).

The connections comes from my OPNsense to the server (Proxmox) via a 10Gbps fiber connection.

I want OPNsense to take car of firewalling dividing the neighbor networks with VLANs. The OPNsense part is done and working, I need to assign to each of the 6 1Gbps NIC each VLAN.

I’ve tagged the traffic going into the server via the fiber connection, but now how can I assign each VLAN to each NIC? Thanks!

Edit: Proxmox has nothing to do in the equation, it just happens to be on the same server where the NICs are.

  • invisiblegorilla@sh.itjust.works
    link
    fedilink
    English
    arrow-up
    2
    arrow-down
    1
    ·
    edit-2
    5 months ago

    Vmbr0 should be your VLAN aware bridge. You create this in the pve networking dashboard.

    Then create vmbr0_101 (where 101 is your vlan). Also create vbmr0_102, and so on.

    Assign those vmbr0_xxx to each of the VMs.

    If you host all the VM’s on the same box, create all the vmbr0_xyz in the pve dash, and in each VM/container>networking assign it.

    • peregus@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      5 months ago

      I don’t need to assign VLANs to VMs, I need to assign them to 6 phisical NICs (tha fact that they are installed in the same machine where there is Proxmox is irrelevant).

      • 4am@lemm.ee
        link
        fedilink
        English
        arrow-up
        3
        ·
        5 months ago

        If Proxmox is already installed on the machine, how are you running OPNSense? If it’s not bare metal, it’s a VM, and if it’s a VM it needs Proxmox’s virtual NICs to be VLAN aware, unless you are doing PCI pass through of the entire network card.

        • HybridSarcasm@lemmy.worldM
          link
          fedilink
          English
          arrow-up
          1
          ·
          5 months ago

          Would they have to be VLAN aware if the switch port was already tagged AND if OP doesn’t care to consider untagged traffic ?

        • peregus@lemmy.worldOP
          link
          fedilink
          English
          arrow-up
          1
          ·
          5 months ago

          OPNsense is in one PC (and it only works as router/firewall), Proxmox is on another PC with all the NICs and Proxmos and it will also work as switch.